Install

I have downloaded Orangepi5max_1.0.0_ubuntu_jammy_server_linux6.1.43.7z. Unzip it and we get a folder Orangepi5max_1.0.0_ubuntu_jammy_server_linux6.1.43.

There are two files in the folder: Orangepi5max_1.0.0_ubuntu_jammy_server_linux6.1.43.img and Orangepi5max_1.0.0_ubuntu_jammy_server_linux6.1.43.img.sha

Go to https://etcher.balena.io/#download-etcher and download it. Burn the .img file into a tf card.

After the board gets an IP, ssh to it.

Both the username and password are the same, orangepi.

ifconfig

It shows the wired network interface is enP3p49s0

Now we assign a static address to enP3p49s0.

sudo vim /etc/network/interfaces

The default content is:

source /etc/network/interfaces.d/*
#
auto lo
iface lo inet loopback

We append the following to /etc/network/interfaces:

# this is a comment line
iface enP3p49s0 inet static
    address 192.168.1.9
    netmask 255.255.255.0

sudo /etc/init.d/networking restart

If it does not work, use nmcli connection show to list current connections, which displays:

NAME                          UUID       TYPE        DEVICE
Wired connection 1            xxxx       ethernet    enP3p49s0

Then run ``nmcli connection mod "Wired connection 1" ipv4.addresses "192.168.1.9/24" ipv4.method "manual"

Then run sudo reboot.

Power off the board and connect it to my mac.

wireless network

$ ifconfig
enP3p49s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.1.9  netmask 255.255.255.0  broadcast 192.168.1.255
        inet6 fe80::e08a:3fa:a528:4b1f  prefixlen 64  scopeid 0x20<link>
        ether c0:74:2b:fd:cd:a1  txqueuelen 1000  (Ethernet)
        RX packets 143  bytes 15875 (15.8 KB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 111  bytes 41059 (41.0 KB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1000  (Local Loopback)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wlan0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        ether c0:f5:35:ed:fb:25  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

so we have wlan0.

Use sudo iwlist wlan0 scan to scan available wireless networks.

It prints something like below:

wlan0     Scan completed :
          Cell 01 - Address: 8C:53:C3:52:CC:3E
                    ESSID:"Xiaomi_CC3D"
                    Mode:Managed
                    Frequency:2.412 GHz (Channel 1)
                    Quality:5/5  Signal level:-55 dBm  Noise level:-81 dBm
                    IE: IEEE 802.11i/WPA2 Version 1
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : TKIP CCMP
                        Authentication Suites (1) : PSK
                    IE: Unknown: DD7C0050F204104A0001101044000102103B00010310470010BC329E001DD811B286018C53C352CC3E102100067869616F6D6910230002523410240004303030321042000831323334353637381054000800060050F20400011011000C5869616F4D69526F7574657210080002210C103C0001011049000600372A000120
                    IE: WPA Version 1
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : TKIP CCMP
                        Authentication Suites (1) : PSK
                    Encryption key:on
                    Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 9 Mb/s
                              18 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 12 Mb/s
                              24 Mb/s; 48 Mb/s
Cell 06 - Address: 1A:8C:3A:63:6D:1B
                    ESSID:"meine"
                    Mode:Managed
                    Frequency=2.437 GHz (Channel 6)
                    Quality:5/5  Signal level:-44 dBm  Noise level:-81 dBm
                    IE: IEEE 802.11i/WPA2 Version 1
                        Group Cipher : CCMP
                        Pairwise Ciphers (1) : CCMP
                        Authentication Suites (1) : PSK
                    Encryption key:on
                    Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 6 Mb/s
                              9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
                              48 Mb/s; 54 Mb/s

$ wpa_passphrase your_wifi_ssid_name your_wifi_password | sudo tee /etc/wpa_supplicant.conf
$ sudo wpa_supplicant -B -c /etc/wpa_supplicant.conf -i wlan0
$ sudo dhclient wlan0

Now ifconfig wlan0 should show its IP address.

Android

  1. Download SDDiskTool_v1.72.zip from https://drive.google.com/drive/u/0/folders/1RFBMuHwbN8V_LsQTnW05KpRKYSGjB6MD and unzip it to get the folder SDDiskTool_v1.72.

  2. Download OrangePi5Max_RK3588_Android13_v1.0.0.tar.gz from https://drive.google.com/drive/folders/1SQcrQI8Qn1MbAcv3ggxhAPyIMTQ2-Xog and unzip it to get OrangePi5Max_RK3588_Android13_v1.0.0.img.

  3. Switch to the folder SDDiskTool_v1.72 and double click SD_Firmware_Tool.exe, - (1) select the sd card - (2) Start from sd card and the click the button on the bottom to format the sd card - (3) Select the android image and burn it

adb shell
getprop ro.build.version.release
getprop ro.product.model
getprop ro.product.manufacturer